Dexcom G6/One
There are 4 Elements to get started⌁
Setup⌁
- Sensor Applicator
- Sensor
- Transmitter
- A Display
Dexcom Intro Userguide⌁
- Prepare for sensor insertion
- Take off Labels (Do not forget to keep Lebels safe or take a photo of your Sensor Code)
you will need the code later.
- Insert a sensor
- Attach transmitter to transmitter holder
Dexcom Insertion Video⌁
If Using A Receiver⌁
I found if I was using xdrip+ I would start the Sensor and Transmitter, first in xDrip.+
Then After the 2 hour Warm up I would then add Sensor code and add the tansmitter Serial Number to the Dexcom Receiver to let it do its process.
I tended not to carry the receiver around with me but liked it at the side of the bed as an extra percaution.
Tips⌁
I also do not use Alcohol wipes to wipe my skin, I prefer to use one of three types of spray's, one is called Cavilon,the other Sorbaderm or Medi Derma-s all 28ml spray with some kitchen roll.
This helps protect my skin but also helps keep the sensors on longer. I spray it on and allow 5 minutes to dry before applying the Sensor Applicator.
Tips 2⌁
When it's time comes to removing the Sensor after 10 days I use a spray called Sensi Care, sting free adhesive releaser. Whick makes it very easy to remove.
Tips 3⌁
And if at any point you feel you are not getting correct readings always do a finger prick. I find it can take a few hours for the sensor to settle in so I will finger prick until I can trust the readings.